Instruction manual

Freeze

This effect freezes the incoming video, as selected on the Main Video Source bus.

Simple as that! There are no parameters, no variations. Press the button once, and

the video freezes, press it again, and it returns to the selected source in full motion.

The Freeze effect is single channel, and can work in conjunction with any transition.

MISC

MISC Mode will have more features added. Currently you can have more features by

the operation procedures as below:

Strobe effect: Press the “MISC” button à 01 keys à Take button

Black and While video effect: Press the “MISC” button à 02 keys à Take button

This effect takes a freeze frame of the selected incoming video at one of four preset

rates. Engage the effect by pressing the MISC button and verifying that the LED on

the button is lit, the rate (1 to 4) is adjusted by pressing the SPD key on the Keypad;

the rate is displayed in the Speed window above the Keypad. 1 is the fastest rate

(more frames per second), 4 is the slowest.

This is a single channel effect and cannot be used with any other transitions or effects.

Effects: Mosaic

The Mosaic effect turns the selected Main Source Video into a grid of colored

squares. Engage the effect by pressing the Mosaic button and verifying that the LED

on the button is lit. There are 8 mosaic patterns to choose from; selected by repeated

presses of the up and down buttons. The patterns are represented by numbers 1-8

displayed in the Effects window above the Keypad.

1 = small mosaic blocks, horizontal and vertical

2 = medium mosaic blocks, horizontal and vertical

3 = large mosaic blocks, horizontal and vertical

4 = very large mosaic blocks, horizontal and vertical

5 = very large mosaic blocks, vertical only

6 = large mosaic blocks, vertical only

7 = medium mosaic blocks, vertical only

8 = small mosaic blocks, vertical only

The effect can be applied to the whole image or one of two window sizes, which can be positioned anywhere

on the screen, using the Joystick in Position Control Mode. The size of the effect window is represented by

numbers 1-2 displayed in the Speed window above the Keypad, and may be changed by pressing the UP

and DOWN Arrow buttons beneath the PIP button.

PIP off = the effect is full screen