User Manual
Table Of Contents
- Contents
- FCC Compliance Statement
- Warnings and Precautions
- Warranty
- Disposal
- Chapter 1 Introduction
- Chapter 2 Connections and Controls
- Chapter 3 Network Setup
- Chapter 4 Switcher OSD MENU
- Chapter 5 Video Streaming
- Chapter 6 Advanced Operations
- Chapter 7 Monitor OSD MENU Options
- Appendices
- Service and Support
12
2.2 Switcher Control Panel
User Memory and Function Keys
User Memory
User Memory buttons 1-6 allow the user to recall and load previously
saved switcher settings.
SHIFT
There are 12 user memory locations. Under normal circumstances,
Buttons USER 1 to 6 represent user memory locations 1 to 6. To load
settings saved in locations 7 to 12 to buttons USER 1-6, simply press the
SHIFT button.
SAVE: User Memory Save
The SAVE button saves the current switcher settings. To save, keep holding down this button and then
select the User Memory number by pressing the corresponding User Memory button.
Normalise Button
The NORM button resets the currently opened menu item to the default values.
Menu Control
Menu Control
Press the MENU button in the HS-1300 function section to enter the
System Configuration Menu. Press the UP, DOWN, LEFT, and RIGHT
arrow buttons to browse the menu options and change values. Use the
ENTER button to save and confirm any setting that has been changed. To
Exit, simply press the MENU button again.
Keyer Selection
Key 1 PGM enables key 1 on the Multi view and PGM output
Key 2 PGM enables key 2 on the Multi view and PGM output
DSK 1 PGM enables DSK 1 on the Multi view and PGM output
DSK 2 PGM enables DSK 2 on the Multi view and PGM output
Key 1 PVW enables key 1 on the Multi view and PVW output
Key 2 PVW enables key 2 on the Multi view and PVW output
DSK 1 PVW enable DSK 1 on the Multi view and PVW output
DSK 2 PVW enable DSK 2 on the Multi view and PVW output