User Manual

33
Key Range (KRange): Key Range sets the range of hues or colors (0 – 360 degrees) that closely match the
background color to be keyed. The user can start with a value of 120 degrees and this value can be fine-
tuned up or down depending on the setup of the green or blue screen studio.
Key Foreground (K Fgnd): Key Background adjusts the performance of the chroma key in light or white
areas. Increase the value if the light areas are becoming too transparent.
Key Background (K Bgnd): Key Foreground adjusts the performance of the chroma key in dark or black
areas. Increase the value if the dark areas are becoming too transparent.
Hi-Light: Hi-light boosts the foreground key in high luminance area.
Lo-Light: Lo-light boosts the foreground key in low luminance area.
Bg-Supp: Background Suppress removes the Luma (Brightness) of the background from the final image. Bg-
Supp turns ON/OFF background suppression.
Mask
The Mask feature allows the user to configure the Mask in chroma mode.
• Left – Left sets the left edge of the Chroma keyer mask.
• Right – Right sets the right edge of the Chroma keyer mask.
• Top – Top sets the top edge of the Chroma keyer mask.
• Bottom – Bottom sets the bottom edge of the Chroma keyer mask.
P-in-P
P-in-P option allows the user to adjust all related P-in-P parameters. Enter this option if the user selects P-
in-P in the Keyer Ctrl sub-option of the Keyer option. “P-in-P Scr” sub-option indicates the keyer enabled
for P-in-P. In our example below, the Key 1 keying effect will be applied to the P-in-P window.
Please note that the “P-in-P Scr” sub-option can only be changed in the Keyer option.
Advanced Mode = Basic Mode
P-in-P
P-in-P Src
Key 1
Position
X
20%
Y
10%
Size
50%
Border
Luma
0%
Sat
0%
Hue
0
Width
0%
Crop
Left
0%
Right
0%
Size
0%
Top
0%
Bot
0%
P-in-P
Fine
Position
The user can adjust the P-in-P window position by adjusting values of X, Y and SIZE, where X is the
horizontal position, Y is the vertical position and Size is the P-in-P window size.
X-Value
Positive value: position the P-in-P window to the right.
Negative value: position the P-in-P window to the left.
Zero value: Position the P-in-P window at the center.