User Manual
Table Of Contents
- Contents
- FCC Compliance Statement
- Warnings and Precautions
- Warranty
- Disposal
- Chapter 1 Introduction
- Chapter 2 Connections and Controls
- Chapter 3 Network Setup
- Chapter 4 Switcher OSD MENU
- Chapter 5 Video Streaming
- Chapter 6 Advanced Operations
- Chapter 7 Monitor OSD MENU Options
- Appendices
- Service and Support
35
Position
The user can adjust the horizontal position of the P-in-P window by adjusting the X value.
• Positive X value positions the P-in-P window to the right.
• Negative X value positions the P-in-P window to the left.
• Zero X value positions the P-in-P window at the center.
Border
P-in-P window border color can be set by adjusting the Luma, Saturation and Hue values. Luma and
Saturation range from 0-100%, whereas Hue ranges from 0-355. The “Width” sub-option adjusts the
border width. A width of zero (0) will turn the P-in-P window border off.
Crop
The P-in-P window crop can be adjusted by modifying the following parameters:
• Left – Adjusts the position of the left edge of the P-in-P window.
• Right – Adjusts the position of the right edge of the P-in-P window.
• Size – Adjusts the P-in-P window crop size.
• Top – Adjusts the position of the top edge of the P-in-P window.
• Bot – Adjusts the position of the bottom edge of the P-in-P window.
P-in-P Lite
In this sub-option, the user is allowed to switch between FINE and NORMAL modes. In FINE mode, the
parameters X can be fined tuned with step size 0.1. In NORMAL mode, the parameters X is adjusted with
step size 1.
Inputs
This feature allows the user to configure the color of the Inputs 1-4. In addition, the user can shuffle the
contents of Inputs 1-6 without changing the hardware connections at the back of the machine. The user
can also select the input source from Clip, Still, Freeze and Live.
Advanced Mode
Inputs
Input 1
Black
0%
White
100%
Chrom
1.0
Input 2
Black
0%
White
100%
Chrom
1.0
Input 3
Black
0%
White
100%
Chrom
1.0
Input 4
Black
0%
White
100%
Chrom
1.0
Freeze
1
Still
2
Live
3
Still
4
Still
5
Still
6
Live
Crosspoint
1
Input 1
2
Input 2
3
Input 3
4
Input 4
5
Input 5
6
Input 6
Basic Mode
Inputs
Freeze
1
Still
2
Live
3
Still
4
Still
5
Still
6
Live
Crosspoint
1
Input 1
2
Input 2
3
Input 3
4
Input 4
5
Input 5
6
Input 6
Input 1-4
By selecting the corresponding input (Inputs 1-4), the user will then be allowed to configure the colour of
the inputs 1-4 by adjusting its Black Level, White Clip and Chroma Gain parameters.