User Manual

36
Freeze
“Freeze” allows the user to load an image to Inputs 1-6 from one of the four sources listed as follows:
• Still
• Freeze
• Live
Crosspoint
In this sub-option, the user can shuffle the contents of Inputs 1-6 without changing the hardware
connections at the back of the machine, or even assign multiple inputs to the same source. For example,
the user is allowed to assign the input 2 video source to input 1, after which the input 2 video will also be
displayed on the input 1 window.
Outputs
This option allows the user to configure various output settings such as video output, audio output, and
GPI Out.
Advanced Mode
Outputs
Output
Sdi 1
Pgm
Sdi 2
Input 2
HDMI
1080P
Audio
Mode
On
Src
Follow
Sdi 1
On
Sdi 2
On
HDMI
On
Tally Mode
Audio Mixer
GPI Out
Off
Mode
Pulse
Width
1
Input 1
Delay
0
MultiViewer
AutoNum
Off
Label Inf
Off
Trns Lab
Off
Basic Mode
Outputs
Output
Sdi 1
Pgm
Sdi 2
Input 2
HDMI
1080P
Audio
Mode
On
Src
Follow
Sdi 1
On
Sdi 2
On
HDMI
On
Outputs
In general, the two SDI output ports (SDI 1 and SDI 2) located on the rear panel as well as the 17.3” built-in
monitor (HDMI) can be configured to output one of the following:
• Input 6
• Input 5
• Input 4
• Input 3
• Input 2
• Input 1
• CLN PVW (Clean PVW)
• CLN PGM (Clean PGM)
• PG + DSK
• PVW
• PGM
• MultiV (Multi view)
In addition to selecting your output source, you are also allowed to set two different resolutions for the
17.3” built-in monitor. The two available resolutions are 1080i and 1080p.