User Manual
Table Of Contents
- Contents
- FCC Compliance Statement
- Warnings and Precautions
- Warranty
- Disposal
- Chapter 1 Introduction
- Chapter 2 Connections and Controls
- Chapter 3 Network Setup
- Chapter 4 Switcher OSD MENU
- Chapter 5 Video Streaming
- Chapter 6 Advanced Operations
- Chapter 7 Monitor OSD MENU Options
- Appendices
- Service and Support
61
Grab Still
Grab
Still 1
Freeze
1
Live
2
Live
3
Live
4
Live
3. In the Load Still sub-option, first select the still picture that you would like to load (Still Num). The
still picture preview is shown in the row right below the Load Still row.
4. Select Load to load the still picture to one of the following destinations:
o Still 1
o Still 2
o Input 4
o Input 3
o Input 2
o Input 1
6.2 Stinger Transition Effect
The Stinger Transition Effect is basically an animated effect added during transition of two video sources.
The animated effect is generated by a clip file which consists of a series of sequential files in
bmp/jpg/png/pic formats. In this section, you will be shown how you can load the existing clip on the
switcher, and import the clip to the switcher from the PC.
Loading the existing Clip for Stinger Transition Effect
The HS-1300 allows you to generate the stinger transition effect. To do this, the user should first load the
clip saved on the machine to the Still 2 window of the Multiview screen first. Please follow the steps
outlined below to load the clip.
1. Press the MENU button to open the OSD menu on the Multiview display.
2. Move to the User Mems menu option as shown below.
User Mems
Load Mem
Memory
13
Load
Save Mem
Memory
13
Save
Load Clip
Load
Clip
0
Thumbnail
Picture - 1
Thumbnail
Picture
Thumbnail
Picture + 1
3. In the Load Clip sub-option, first select the clip that you would like to load. The Clip Preview is
shown in the row right below the Load Clip row.
4. Select Load to load the clip to the Still 2 window. The load progress prompt “Loading Clip
XX/XX ...” will appear. Once loaded, the previously displayed video or image will be replaced.
Note: The load process can take up to tens of seconds.
5. To enable the Clip or Stinger transition mode, please press the MIX and WIPE buttons at the same
time.
Importing the Clip for Stinger Transition Effect from the PC
On the HS-1300, you will be able to add a clip between sources. Besides using the existing clips on the
machine, you are also allowed to import your own clip (a series of bmp/png/jpg/pic files) to the HS-1300