User Manual
Table Of Contents
- Contents
- FCC Compliance Statement
- Warnings and Precautions
- Warranty
- Disposal
- Chapter 1 Introduction
- Chapter 2 Connections and Controls
- Chapter 3 Network Setup
- Chapter 4 Switcher OSD MENU
- Chapter 5 Video Streaming
- Chapter 6 Advanced Operations
- Chapter 7 Monitor OSD MENU Options
- Appendices
- Service and Support
62
from the PC using the Switcher Image Import/Export utility, which can be downloaded from the HS-1300
product page.
• First connect the HS-1300 to a Windows computer using an RJ-45 Ethernet cable.
• Since the HS-1300 has a default IP address of 192.168.100.101 so the computer should be given the
IP settings that match the same IP range as the switcher.
• Turn on the Windows computer and manually set the IP to 192.168.100.X within the Windows
Network and Sharing Centre.
• Now install the Switcher Image Import/Export utility on the computer.
• After the utility is installed, click and open the user interface as shown below.
Click Setup on the MENU SELECT pane
and if the connection between the HS-
1300 and the PC has been successfully
established, you will be able to see the
network information of your switcher.
Select Import-Export
from the yellow
menu options.