User's Manual

10
 Push and hold one of the RECORD and STREAM buttons until the pushed
button starts blinking red.
 As soon as the pushed RECORD or STREAM button is released, the BITRATE
button will turn solid red.
 While the BITRATE button stays solid red, push it to switch between different
bitrate modes (H, M or L). Please note that the BITRATE button will return to
solid white after a few seconds if button push is not sensed.
 To exit, push the the RECORD or STREAM button again.
Note: The system will return to the previous setting if the BITRATE button is not
pushed. The default bitrate is M.
H/M/L LED Indicators
ON (Green): Bitrate mode enabled
OFF: Bitrate mode disabled
RECORD Button
The RECORD button activates and deactivates the RECORD Only
mode; follow the steps outlined below:
Start recording
 When idle, the RECORD button is solid white.
 Press and hold the RECORD button for approximately 2 seconds.
 When the record function is activating, the RECORD button turns from solid
white, then blinking red and finally to solid red.
 When the RECORD button turns solid red, this indicates that the record
function has been successfully activated.
Stop recording
 While recording, the RECORD button is solid red.
 Press and hold the RECORD button for approximately 2 seconds.
 When the record function is terminating, the RECORD button turns from solid
red, then blinking red and finally to solid white.
 When the RECORD button turns solid white, this indicates that the record
function has been successfully terminated.