User's Manual

51
 When the stream function is terminating, the STREAM button turns from
solid red, then blinking red and finally to solid white.
 When the STREAM button is solid white, this indicates that the stream
function has been successfully terminated.
Bitrate Button
Follow the steps below to switch the stream bitrate mode using the BITRATE button:
 Push and hold one of the RECORD and STREAM buttons until the pushed
button starts blinking red.
 As soon as the pushed RECORD or STREAM button is released, the BITRATE
button will turn solid red.
 While the BITRATE button stays solid red, push it to switch between
different bitrate modes (H, M or L). Please note that the BITRATE button will
return to solid white after a few seconds if button push is not sensed.
 To exit, push the the RECORD or STREAM button again.
Note: The system will return to original settings if the BITRATE button push is not
sensed. The default bitrate is M.
Vertical Button
Press the Vertical button to switch video orientation between Portrait and
Landscape modes.
3.5 Restoring Factory Defaults
On the system page, scroll down to System Control in which you should be able to
find the Restore to Default button. Click to restore the system’s factory defaults.
Alternately, you can follow the steps below to restore the NVS-34’s factory defaults.
1. Power cycle NVS-34.
2. During device bootup, the BITRATE, VERTICAL, RECORD and STREAM buttons
should illuminate solid red.
3. The device bootup should be complete approximately after 30 seconds and the
BITRATE, VERTICAL, RECORD and STREAM buttons will turn solid white.
4. Simultaneously press and hold the RECORD and STREAM buttons until the
BITRATE, VERTICAL, RECORD and STREAM buttons turn red.