User's Manual

9
selected on the Main Source bus is automatically selected.
If A+V is not engaged, the input source is user selectable.
Level controls for each input source are the rotary pots
below the selection buttons.
5. A+V: Audio follow video switch. When this button is
engaged (you’ll know it is engaged because the LED is lit),
the audio associated with a selected input source
automatically follows the video through the
dissolve. When the button is inactive, audio
must be switched manually.
6. Color Processor: These controls become active in
conjunction with the Input Format selector (3.). When that
control is active, you can make adjustments to the
selected channel’s brightness, contrast, color, and tint
(NTSC only) by pressing the up and down arrow buttons.
The LEDs on the left side of this section indicate relative
steps above or below unity (the signal exits the control
unchanged). Press and hold the Reset button in the upper
right for 2 seconds or more to reset the Color Processor
controls all to unity.
The “Reset All”
button resets the
color correction and
RGB correction
settings for all 4
inputs.
18
Set up RMC-120 IP address
Step 1: Double click or Config Icon
Step 2: Click on the Search Button
Step 3: Click on the MAC List