User's Manual Part 1

The equipment has been tested and found to comply with the essential requirements and other relevant provisions of Directive
1999/ 5/EC These limits are designed to provide reasonable protection against harmful interference in a
residential installations.
It is in compliant with the European Norm for Product standard (CE) to demonstrate the compliance of mobile phones
with the basic restrictions related to human exposure to electromagnetic fields.
The PocketSurfer2 device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission (FCC) of the U.S Government, Industry Canada of the Canadian
Government (IC) and recommended by The Council of the European Union (EU).
This equipment generates uses and can radiate Radio frequency energy. If not installed and used in accordance with the
user manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
This PocketSurfer2 meets Government Requirements for Exposure to Radio Waves. It is a radio transmitter and receiver
and is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the
Federal Communications Commission (FCC) of the U.S. Government, Industry Canada of the Canadian Government (IC) & The
Council of European Union (EU).
These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population.
The guidelines are based on standards that were developed by independent scientific organizations through periodic and
thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all
persons, regardless of age and health.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment Off and On, the user is encouraged to try to correct the interference by one or more of the following measures:
with exposure guidelines while using your PocketSurfer2 device, use only
accessories that are supplied or approved by the manufacturer.
that are not expressly approved by DataWind might violate and exposure guidelines
and might void any applicable to the PocketSurfer2 device.
to this equipment not expressly approved by DataWind Ltd. for compliance could void the
user’s authority to operate this equipment.
6
6
6
6
Change the orientation or try to relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer, manufacturer or an experienced authorised technician for help.
To maintain compliance FCC, IC and EU, RF
Use of accessories FCC, IC EU, RF
warranty
Changes or modifications
Radio Interference Information:
Chapter 2
Important Safety Information