User's Manual

7. My PrintStik does not seem to be pairing with my Personal Computer. What

should I do?

In order to pair, please look at the section of this instruction manual that addresses

pairing the PrintStik with a PC. Make sure the PrintStik is on when pairing and

be sure to refer to the manual of Bluetooth connectivity of the personal computer

being paired with the PrintStik.

8. My PrintStik will not print from my personal computer. How can this be fixed?

In order to address this, you want to first make sure that the PrintStik has been

properly paired and that the serial port is connected. Refer to information

regarding this stated earlier in this instruction manual. Make sure the PrintStik is

close enough to be receiving the Bluetooth signal.

9. When trying to pair I am continually asked for a code to be entered? What should

I do?

The code that you are referring to is for pairing the PrintStik with other devices

and that number to enter is “0000”.

10. I want to pair with other Bluetooth enabled devices other than my blackberry.

Will it work?

The PrintStik will continually have more drivers available at no charge for it to be

able to pair with many devices like SmartPhones. Please keep abreast with the

latest from our website for when these are made available.

11. My PrintStik will not turn on.

This may simply be because the PrintStik needs to be charged. You can follow

the charging information that is given earlier in this instruction manual. If you

have charged it and this is still happening, please contact our technical support for

more information.

12. How long does it take to charge?

It would take 120 minutes to fully charge the PrintStik. Refer to the color of the

battery life symbol to understand the level of battery life it would currently have.

13. Can the PrintStik be used while it is being charged?

The PrintStik does have the ability to work while it is being charged. However, it

is recommended to disconnect the PrintStik from being charged when it is being

used. It should only be connected to a power source to charge.