User's Manual

1 DATECS DPP-250 User manual

•SW2: Disable CR / CR is executed as LF

•SW3: Enable/Disable LF

•SW4: LF immediately after CR/ Disable LF immediately after CR

•SW5: Font A (12x24)/ Font B (9x16)

•SW6-7: Reserved for future features.

•SW8: Prevents others from discovering printer when set to ENABLE.

Must be set after pairing is completed.

•SW9: Disable/Enable USB. Allow the use of USB port for communications.

•SW10: (OFF) set USB as the host mode. Host/Device

11. Pairing Info Details

 BAUD RATE: Default is 115200

 AUTO OFF TIME: Default is 5 minutes

 PRINT DENSITY: Default is 100%

 CHARACTER TABLE: Default is WESTERN (1252)

 PAIRING INFO: Default is (SAVE=No)

Notes:

When saving pairing information, the printer remembers Bluetooth

information of the last device connected (paired) to the printer.

Saving pairing info prevents the printer from asking for passkey

upon initialization. The process for using this option is described

below. "To speed this programming process, you may bypass the memory

switch settings by indicating "NO" via pressing of the <ON/OFF>

button when the printer prints "CHANGE MEMORY SWITCHES" as

shown on page 17. This will advance you to the next level of

setting where pairing can be found".

1. Following instruction on page-13, change the Pairing Info option to

[Save = Yes].

2. Turn the printer on and pair the printer to your Bluetooth device.

3. The printer will now remember the pairing information and not

prompt user for a passkey on every printer initialization.

Clearing Pairing Info:

1. Following instruction on page-13, change the Pairing Info option to

[Save = No].

2. Turn on the printer and pair the new Bluetooth device to the printer.

3. The printer will prompt user for a passkey on every printer

initialization.

11. Communications Configuration