User's Manual

1 DATECS DPP-250 User manual
26
When placing the card into the reader, the smart chip must
be facing to the front of the printer as show in the figure
above. Insert the card in to the reader until the card stops.
User Notes:
To use the smart card reader feature, special software must
be used to read and process the smart chip information. Please
consult your reseller if this software is available or contact DATECS
for recommendations on compatible third party software solutions.
17. Replacing Battery
To replace the battery in the DPP-250 thermal printer follow
the steps below.
Steps:
1. Turn over the DPP-250 and place on a flat
surface. Rotate the (2) locking levers as
shown in the figure on the right.
2. Lift the battery cover as showed in the
figure on the right.