User's Manual

1 DATECS DPP-250 User manual
29
20. List of commands for ESC/POS mode
№ Command Description
1 BEL Sounds the buzzer
2 HT Horizontal Tab command
3 LF Printing а line and Paper Feeding command
4 FF Printing and paper feeding to the black mark position
5 CR
The operation of the command depends on the state
of the
configuration flags 2, 3 and 4
6 DC2 = Image LSB/MSB select
7 DC3 ( DC3 (Ruled line) commands sequence start
8 DC3 + Sets the ruled line ON
9 DC3 - Sets the ruled line off
10 DC3 A Selects ruled line A
11 DC3 B Selects ruled line B
12 DC3 C Clears selected ruled line buffer
13 DC3 D Sets a single dot in selected ruled line buffer
14 DC3 F Ruled line pattern set
15 DC3 L Ruled line set
16 DC3 M Selects ruled line combine mode
17 DC3 P Ruled line 1 dot line print
18 DC3 p Ruled line n dots line print
19 DC3 v Ruled line image write
20 CAN Canceling print data in page mode
21 ESC FF Printing data in page mode
22 ESC RS Sounds the buzzer
23 ESC SP Setting character spacing
24 ESC # Setting EURO symbol position
25 ESC $ Specifying the absolute horizontal position of printing
26 ESC %
Selecting/Canceling the printing of downloaded user
character set
27 ESC & Selecting user character set
28 ESC ! Specifying printing mode of text data
29 ESC * Printing graphical data
30 ESC + Switch’s OFF the printer
31 ESC - Selecting/Canceling underlining
32 ESC . Printing self test/diagnostic information
33 ESC 2 Specifying 1/6-inch line feed rate
34 ESC 3 Specifying line feed rate n/203 inches
35 ESC < Changes print direction to opposite
36 ESC = Data input control
37 ESC > Selecting print direction
38 ESC ? Reading magnetic stripe card
39 ESC @ Initializing the printer
40 ESC CAL Black mark mode sensor calibration