User's Manual

1 DATECS LINEAPRO 11 INDUSTRIAL

USER MANUAL

v1.1.0 5

REGULATORY

FCC ID: YRW-LINEAPRO11I

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

•Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modiﬁcations to this device not explicitly approved by manufacturer

could void your authority to operate this equipment.

RF Exposure Information and Statement

This transmitter must not be in co

location or operating in conjunction with any other antenna or

transmitter. This device complies with FCC RF radiation exposure limits set forth for an uncontrolled

environment.

This device should be installed and operated with a minimum distance of 5 mm between

the device and your body.