User's Guide

DATECS
DATECS
BLUEPAD-55 V2 USER GUIDE
Page 13 of 23
The battery is charged by the USB power adapter, from connector position “6”.
The BLUEPAD-55 v2 is switched on and off by pressing the button.
There are four general purpose LEDs:
The BLUEPAD-55 v2 comes with a USB communication cable.
The USB communication cable is connected to the BLUEPAD-55’s v2 mini-USB connector 1.
For reading of an ICC, the card has to be inserted manually into the card slot 3.
The card slides into the BLUEPAD-55 v2 bottom ICC slot until the end of the slot it reached and slight
“click” is felt.
After reading, the card has to be pulled out manually until fully extracted.
Setup
When a BLUEPAD-55 v2 is switched on and the button is kept pressed, on the display will be
shown the name and the version of the Secure Boot Loader and the firmware.
Service personnel can access two different system modes: Service Mode and Application
Download Mode.
SERVICE MODE
To enter Service Mode for key loading and test operations, the button DOWN has to be pressed while
switching on the BLUEPAD-55 v2.
The following keyboard buttons can be used in service mode:
UP: move through the list one position upwards
DOWN: move through the list one position downwards
OK: selection of the active option
C: return to previous level or exit the service mode
The following menu options can be selected in service mode:
INFO VERSION
INFO HARDWARE
INFO KEYS
TEST DISPLAY
TEST KEYBOARD
TEST MSR
TEST SCR
KEYS DOWNLOAD
DELETE DEA KEYS
EXIT
INFO VERSION
Shows the serial numbers and the versions of the detached program modules: