User's Manual

9. Adjusting the Level of Brightness

The Combat Command LCD Display can be set to the preferred level of brightness. In order to

adjust the level of brightness, please follow these steps:

Step 1:

Press and hold the F1 and F2 Buttons

Step 2:

Whilst continuing to press and hold the F1 and F2 buttons increase and decrease the level of

brightness by moving the direction buttons up and down as shown.

10. Entering and Exiting the TurboFire EVO Menu

Step 1:

Each time you wish to access the TurboFire EVO Menu you need to short tap the Home button

on the TurboFire EVO controller. Access the usual Xbox guides when pressing and holding the

Home button for over a second.

Step 2:

Whilst you are within the TurboFire EVO menu the TurboFire EVO buttons and controls will

only allow you to control the TurboFire EVO menu. In order to exit the TurboFire EVO Menu

and regain control of your console, you need to tap the Home button, Back button or B button.

11. Activating Features

It is possible to set each of the features to activate in one of five ways. You can choose to

activate and deactivate a feature by pressing the F1 or F2 button. You can choose to activate a

feature when you are pressing and holding the F1 or F2 button. Alternatively you can choose to

have a feature set to always on, meaning that you do not need to press any button to activate

the feature. When activating features you can use multiple instances of some features such as

Rapid Fire and Sniper.

When you have entered the TurboFire EVO menu as detailed in the previous section, using the

Left Analog Stick or the Direction buttons enables you can scroll between the four features.

With the feature which you wish to activate highlighted, using the X button on the TurboFire

EVO you can toggle the highlighted feature between the five different activation modes. Each

of the activation modes is indicated by an icon being added to the highlighted feature as

follows:

12. Pre-installed Features

The TurboFire EVO is preinstalled with the features Sniper, Remap, Rapid Fire and Low recoil.

Each of the pre-installed features is easily identifiable by the following feature images:

Tap X

Activate and deactivate by pressing the F1 butt on

Tap X

Activate when you are pressing and holding the F1 butt on

Tap X

Activate and deactivate by pressing the F2 butt on

Always on

Tap X

Activate when you are pressing and holding the F2 butt on

Sniper Mode

Remap

Rapid Fire

Low Recoil