User's Manual

Before you can use the TurboFire Wireless Controller for the first time you need to
sync it with your Xbox 360.
To do this, press the ‘Xbox Guide Button’ on the front of the controller so that the
player indicator number lights begin to flash continuously. Next press the ‘Sync
button on the rear of the controller so that the player number indicator lights
whilst continuing to flash alternate between the player numbers. To complete the
syncing process, press the Sync’ button on the front of the machine.
After a few seconds the controller and console will be synchronised and a player
number will be assigned to the controller and displayed on the player number
indicator.
The TurboFire controller is equipped with a unique programmable Turbo Rapid
Fire function that can boost your firepower in any Xbox 360 game. The Turbo
Rapid Fire function has 3 mode settings and can be assigned to wide range of
buttons.
Each of the mode settings allow the Turbo Rapid Fire to run at its fastest speed
but each mode includes a very slight timing difference which is required for some
games.
By default, Turbo Rapid Fire is assigned to the Right Trigger button but different
games will use different buttons for actions like jump, shoot, block etc. In order
for you to get the most out of the rapid fire function you can choose exactly which
button or buttons it is assigned to.
To program which buttons will use rapid fire, press and hold the TURBO button
and then any one of the buttons shown in the illustration below. When you have
made your selection, release the TURBO button. Turbo Rapid Fire can be
enabled on the following 8 buttons:
LT Button
LB Button
Press one or more of these buttons
Press and
Hold Turbo
RT Button
RB Button
1
2
Button
Button
Button
Button
Y
X
B
A
The TurboFire Wireless Controller will remember this configuration until the
batteries become flat or are removed or the process is repeated to configure a
different set of buttons.
After assigning Turbo Rapid Fire to one or more buttons (see previous section)
the Turbo Indicator Light on both handles of the pad will illuminate. This indicates
that Turbo Rapid Fire is running in mode 1. To set the Turbo Rapid Fire to mode
2 or mode 3, tap the Turbo button one or more times.
Step 2: Enable rapid fire and set the fire speed
Step 1: Choose Rapid Fire Buttons
6. Using the Turbo Rapid Fire function
5. Syncing the Controller