User manual

8 Operation DATEQ XTC II manual EN
Master section
The XTC II master section holds a 2x30 segmented VU-meter showing
the master mix or cue level accurately.
The master volume control can adjust the master-mix volume. The
balance adjusts the master left-right balance.
The monitor control adjusts the volume of the monitor speakers. This is
completely independent of the master volume and balance settings.
The Phones control adjusts the volume for the headphones. The SPLIT
button controls the split button, its status shown by the front indicator.
Split ON means that the left channel holds the mono Cue signal and the
right channel the mono Master signal, audible on the headphones as
well as visible on the VU-meter.
Split OFF means that both the left and right channel hold the Cue signal,
audible on the headphones as well as visible on the VU-meter.
The headphone signal is available on the top as well as the front
connector.
Cross fader
The Cross(X) fader function can be routed to any fader channel and can
be disabled by means of the Setup-Xfader button.
Channel 2 and 3 can be routed to the left (A) side and channel 4 and 5
can be routed to the right (B) side of the cross fader. (see the Setup chapter).
The X-fader has a fully adjustable curve, with which the operational range can be trimmed from
super short (5mm) to full fader-lenght and everything in between, controlled by the red CURVE
trimpot.
+6
3
-5
0
10
20
30