User manual

10 Setup DATEQ XTC II manual EN
Jumper settings
!!
To be able to reach the internal jumpers the AC-cord has to be disconnected
from the mains first. Then the 8 torx screws of the front panel can be
unscrewed and the front panel can be flipped open gently .
MIC Phantom voltage
Inside left, at the back, on the top board the Mic-Phantom jumper
is situated. This controls the phantom voltage:
ON is top position,
OFF is the bottom position.
Phono / Line select
Inside, at the back, on the bottom
board the Phono/line jumpers are
situated. These control the input
sensitivity of channel 2,3 and 4:
LINE is the top position,
PHONO is the bottom position.
DJ Cleanfeed
On the VCA-board mounted at the
back of the Main-board (front) the
Cleanfeed DJ jumpers are
situated. These jumpers control
the DJ signal to be filtered out of
the monitor O N, or not OFF:
CF-OFF is the right position(2x),
CF-ON is the left position (2x).
Limiter lock
At the back of the Main-board (front) under the VU-meter the limiter-lock option named “Lock” is
situated. The 2 pins “ON” control this option:
ON is linked,
OFF is open.
!!
The front panel can now be closed gently and the 8 torx screws fastened.
Then the AC-cord can be connected to the mains.
Phono/Line
Chan.2 Chan.3 Chan.4
Phantom
Cleanfeed DJ