User guide

uNAS/tNASUserGuideVersion1.0 Page17

By pressing a combination of left CTRL key, left ALT key and t, you can run Console Tools. The menu will
appear, with choice of following functions: Ping, DHCP Ping, Hardware info, Memory info, Time
configuration and DNS configuration.
CTRL+ALT+x
By pressing the left CTRL key, left ALT key and x, it will display extended tools.
CTRL+ALT+w
By pressing the left CTRL key, left ALT key and w, it will display hardware configuration.
CTRL+ALT+r
By pressing the left CTRL key, left ALT key and r, it will display CLI Management Tool for RAID controller
CTRL+ALT+f
By pressing the left CTRL key, left ALT key and f, it will display CLI Management Tool for Fibre Channel
controller.
CTRL+ALT+h
By pressing the left CTRL key, left ALT key and h, it will display hardware and driver information.
F1, F2 and F5
Function key F1 is available to display help information while F5 will reset the console display to default. If
you press F2 key all network interface will be displayed.
Shutting down and restarting
With Ctrl + ALT + DEL the uNAS/tNAS host computer will be shut down and restart, while CTRL + ALT + S
shut it down. Please be careful with this option when users are connected.
ESC menu
Boot menu is available by pressing ESC after POST (Power-on self-test) during the initial start of
uNAS/tNAS system. After pressing ESC, there will appear menu with possibility of launching NAS-R3 in
different procedures of work or memory testing:
• -Single - system launch with (kernel) for one CPU,
• -SMP - system launch with (kernel) for more CPU's system,
• -x86 - system launch with restrictions of 4GB RAM(this procedure should work on every unit with CPU
better than 386 and with CPU C3),
• -Single (Intel I/TA support) - system launch in procedure with one CPU,
• -SMP (Intel I/TA support) - system launch in multiple-CPU,
• Memtest - after choosing this option, memory of the system, where uNAS/tNAS is installed, will be tested,
Apart from test, there are also available information about the memory itself and its settings,
• RESCUE_MODE - in this option, only driver which enables access to the net are loaded (if there is a need
to connect using remote support).