User guide

uNAS/tNASUserGuideVersion1.0 Page22

Function: Bond interface settings
Here you can edit a bonding network interface.
To remove network interface form bonding select it in field remove and click "apply" button.
Bonding can be deactivated by setting of "Active" option. You can change bonding interface
network configuration, you can use static or dynamic (DHCP) network configuration.
Each network interface is that belongs to bonding interface is described by following fields:
Primary - A string (eth0, eth2, etc) specifying which slave is the primary device. The
specified device will always be the active slave while it is available. Only when the primary is
off-line will alternate devices be used. This is useful when one slave is preferred over
another, e.g., when one slave has higher throughput than another. The primary option is only
valid for active-backup mode.
Interface - Network interface name
State: - Shows if NIC is connected.
Function: Remove bonding
Here you can remove a bonding interface.