User's Manual

HH7700-MSOP 3-7
3: Radio Operation
programmed frequencies and channel 12 is the priority channel.
After scanning the priority channel, the scan cycle continues with
channel 1.
When a signal is detected on a channel, the monitor icon is
displayed, the channel or frequency flashes and activity on the
channel is heard.
Scanning pauses for 5 seconds unless tone decoding is enabled on
some or all channels in which case the scan rate slows down as
the radio decides whether or not there is something worth
listening to.
When the signal ends or 5.0 seconds is up, scanning resumes.
3. Press
DUAL WATCH again to stop scanning.
Note: If the radio finds something of interest on a non-priority
channel, it continues to monitor the priority channel. If the radio
finds something of interest on a priority channel, it stays there. If
something of interest is found on both a non-priority and priority
channel, the radio stays on the priority channel.