User's Manual

HH7700-MSOP 3-11
3: Radio Operation
Whisper Feature
Whisper increases the sensitivity of voice transmission. The validity of
its use must be taken into consideration before being programmed into
the radio. A
WHISPER button must be assigned by the Programmer for this
feature to work. When Whisper is enabled,
W is displayed. When scan is
activated, Whisper is overridden.
The Whisper status is retained when the radio is turned off.
CAUTION: Not to be used with the VOX feature.
Cloning a Radio
Programmed data can be copied between 2 radios.
1. Connect the cloning cable to the radios.
2. Place both radios into cloning mode by pressing
MONITOR and ▲
simultaneously while turning the radio on. The following screen
is displayed on both radios.
3. Press
P1 on the transmitting (master) radio.
A beep sounds when the transfer of data is finished.
END is
displayed on the sending radio for 2 seconds followed by
CLO-M.
After the receiving radio gets the data,
CLO-M is displayed.
Note: If cloning fails, the radio beeps and ERR is displayed for 2
seconds followed by
CLO-M.