User's Manual

Internet Connection
Type
Select Static IP to begin configuration of the Static IP connection.
Account Name Enter the account name provided by your ISP.
Domain Name Enter the domain name provided by your ISP.
MTU Specify the Maximum Transmit Unit size. It is recommended you
accept the default setting of Auto. Otherwise, packets will be
fragmented downstream if the MTU is set too high or too low,
which impacts network performance. In extreme cases, an MTU
setting that is too low can prevent the OM2P from establishing
some connections.
IP Address Enter the WAN port IP address.
IP Subnet Mask Enter the WAN IP subnet mask.
Gateway IP Address Enter the WAN gateway IP address.
Primary DNS Enter the primary DNS IP address.
Secondary DNS Enter the secondary DNS IP address.
Discard Ping on WAN Check to Enable to recognize pings on the OM2P WAN interface
or Disable to block pings on the OM2P WAN interface. Note:
Pinging IP addresses is a common method used by hackers to
test whether the IP address is valid. Blocking pings provides some
extra security from hackers.
Accept / Cancel Click Accept to confirm the changes or Cancel to cancel and
return previous settings.
Clicking Accept does not apply the changes. To apply them, use Status > Save/Load (see
section 4.1).