User's Manual

11.3 SNMP Settings
Click the SNMP Settings link under the Management menu to monitor network-attached
devices using the Simple Network Management Protocol (SNMP). SNMP allows messages
(called “protocol data unit’s) to be sent to various parts of a network. Upon receiving these
messages, SNMP-compatible devices (called agents) return data stored in their Management
Information Bases.
SNMP Enable/Disable Enable or disable the OM2P SNMP function.
Contact Enter the contact details of the device.
Location Enter the location of the device.
Community Name Enter the password for accessing the SNMP community for
read-only access.
Community Name Enter the password for accessing the SNMP community for read
and write access.
Trap Destination IP
Address
Enter the IP address where SNMP traps are to be sent.
Trap Destination
Community Name
Enter the password of the SNMP trap community.
Save/Apply / Cancel Click Save/Apply to apply the changes or Cancel to return
previous settings.
Clicking Save/Apply change the setting immediately. You cannot undo the action.