User's Manual

Wireless Client
Step1 Select the wireless mode with which you want to associate.
Step2
Use site survey to scan nearby Access Point and either select the
Access Point to which you want to connect, or enter the SSID
manually.
Step3 Configure the VLAN ID in your wireless device if available.
Step4 Select the appropriate authentication type and password.
Access Point Mode does not provide DHCP server, so the Wireless Client IP address
must be configured manually using the same Local Area Network subnet.
12.2 Client Bridge Mode
Client Bridge Mode functions like a wireless dongle. It must connect to an Access Point/AP
Router to join the network.
Refer to Chapter 13 to check the Access Point’s configuration.
Client Bridge
Step1 Log in to the Web Configurator with the default IP address
192.168.1.1
Step2 Select your country or region’s regulation.
Step3 For Operation Mode, select Client Bridge from System
Properties.
Step4
Use site survey to scan Access Points that are available in nearby
areas.
Step5 Select the Access Point with which you want to associate.
Step6
Set up the authentication settings that match the Access Point’s
settings.
Step7 Click Apply to save all changes.
The Client Bridge IP settings must match the Access Point’s subnet.