User's Manual

12.4 Client Router
In Client Router Mode, the OM2P’s internal DHCP server allows LANs to automatically
generate an IP address to share the same Internet. Connect an Access Point/WISP wirelessly
and connect to LANs using a wired connection.
Refer to Chapter 13 to check the Access Point’s configuration.
Client Router
Step1 Log in to the Web Configurator with the default IP address
192.168.1.1
Step2 Select your country or region’s regulation.
Step3 For Operation Mode, select Client Router from System
Properties.
Step4 Change your Local Area Network setting to Obtain an IP
Address Automatically.
Step5
Use site survey to scan Access Points that are available in nearby
areas.
Step6 Select the Access Point with you want to associate.
Step7
Set up authentication settings that match the Access Point’s
settings.
Step8 Set your WAN connection type using the WAN settings provided
by your ISP.
Step9 Click Apply to save all changes.
Client Router’s IP setting must match to the Access Point’s subnet.
Chapter 13 Building a Wireless Network
With its ability to operate in various operating modes, your OM2P is the ideal device around
which you can build your WLAN. This appendix describes how to build a WLAN around your
OM2P using he device’s operating modes.