User manual

Soundtower Evolver PlugSE V1.0 12
SEQUENCER EDITING
This enlarged view of the sequencer allows easier adjustment of the individual steps. The same controls
appear at the top of the window along with four small windows showing the current levels of each of the four
sequencers. Clicking on any of these areas will bring the values down the larger window for easy editing.
Select the sequencer you wish to adjust by clicking on the mini view of one of the four available.
Select the Evolver parameter you wish the sequencer to track in the SeqxDestination (x = 1, 2, 3 or 4).
Set ClockDivide and click the SEQ button on top application bar to engage the sequencer (see SEQUENCER
button section above).
Depending on mode selected in the DrawMode menu, slide the handle of each step or drag across the
panel to set the levels of each step. The values in the step handle will depend upon the SeqxDestination. That
values will be either numeric or indicate midi note names and numbers. Please note that the level can also be
adjusted with a scroll wheel of a mouse.
At the top of each step column is a button that will display either RST (ReSeT), or OFF(only Sequencer 1).
The OFF function in the Editor is equal to a reset as noted in the Evolver manual. RST will be the point were
the sequence loops back to the beginning. Again, refer to the Evolver manual for details on programming the
sequencer.
When nished, click OK to return to the normal Sequencer window.