Specifications

Somewhat related, the Audio In setting will generate a gate from the Audio
Input. When the signal gets above a certain level, the gate will go on. When it
drops below that level, the gate will go off.
Clock Parameters
The sequencer and arpeggiator share the BPM and CLOCK DIVIDE settings.
BPM: 30…250 — Sets the programmed tempo for the sequencer in BPM (beats
per minute).
Clock Divide: see table — Sets the note value for each sequence step relative to
the BPM.
Display Tempo Timing Division
Half
BPM/2 Half note
Quartr
BPM Quarter note
Eighth
BPM x 2 Eighth note
8 half
BPM x 2 Eighth note, half swing timing
8swing
BPM x 2 Eighth note, full swing timing
8 trip
BPM x 3 Eighth note triplets
16th
BPM x 4 Sixteenth note
16half
BPM x 4 Sixteenth note, half swing timing
16swng
BPM x 4 Sixteenth note, full swing timing
16trip
BPM x 6 Sixteenth note triplets
32nd
BPM x 8 Thirty-second note
32trip
BPM x 12 Thirty-second note triplets
64trip
BPM x 24 Sixty-fourth note triplets
Arpeggiator Parameters
Mopho’s arpeggiator has four different operating modes and can be synced to a
MIDI clock source.
Note: If the arpeggiator does not seem to be working, check the G
LOBAL
parameters to make sure Clock is set to Internal. If Clock is set to use an
external clock source, Mopho must be receiving MIDI clock messages in
order for the arpeggiator to run.
The tempo and note value are determined by the Clock Parameters.
23