User's Manual
Table Of Contents
- System overview
- Implementation modes
- Firing in WIRED mode
- Firing in WIRELESS mode
- Safety lockout
- Dealing with errors during the firing phase
- Dealing with errors during synchro-line test procedure
- Error messages during the procedure
- Error messages during the DBD auto-test
- Error messages during the line test
- Error messages during detection of extra dets
- Error messages during detonator self-test
- Special procedure
- Error messages during charging and firing authorized window
- Error messages during charge test
- Error message with a Swift detonator
- History and Datalogger File Transfer
- Additional procedures
- Maintenance
- Battery management
- Power consumption and battery autonomy
- Recharging the battery
- Battery calibration
- Battery status indicator – Used battery
- Cleaning
- Annual inspection
- Auto test / Self-test
- Software revisions
- Rating and characteristics of fuses
- Symbol and Tags
- Range of environmental conditions
- Assembly, location and mounting
- Connections
- CONTACT US
Page 24 / 168
Display
The display properties can be configured as indicated in the screen below. Increase/Decrease the
backlight level by using the left / of the DRB2. Change the selection between LCD backlight
and Keyboard backlight using the / of the DRB2. Select ON/OFF using the left / of the
DRB2. Confirm new parameters with or use to exit to the GENERAL SETTINGS without
taking the modification into account.
DRB2 Modem
As indicated in the screen below, the operator can select between Internal/External modems and
configure repeater setup. Refer to the chapter "Setup blasting system for wireless mode".
√
X