Manual

ManualsBrandsDavey ManualsWater equipmentEcoSpa Salt Water Spa Sanitisation System

Please pass these instructions on to the operator of this equipment.

The installation of this product should be carried out by a person knowledgable in

spa pool plumbing requirements following the Installation Instructions provided in

this manual.

WARNING: Failure to follow these instructions and comply with all applicable

codes may cause serious bodily injury and/or property damage.

* Installation and operating instructions are included with the product when purchased new.

They may also be found on our website.

P/N MMAN010-3 supersedes MMAN010-2

AUSTRALIA

Davey Support Centre

6 Lakeview Drive,

Scoresby, Australia 3179

Ph: 1300 367 866

Fax: 1300 369 119

Website: davey.com.au

Davey Water Products Pty Ltd

Member of the GUD Group

ABN 18 066 327 517

NEW ZEALAND

Customer Service Centre

7 Rockridge Avenue,

Penrose, Auckland 1061

Ph: 0800 654 333

Fax: 09 527 7654

Website: daveynz.co.nz

® Davey is a registered trademark of Davey Water Products Pty Ltd.

Installation and

Operating Instructions

Salt Water Spa

Sanitisation System

Eco

Spa

™

Summary of content (6 pages)

PAGE 1
EcoSpa ™ Salt Water Spa Sanitisation System Installation and Operating Instructions AUSTRALIA NEW ZEALAND Davey Support Centre 6 Lakeview Drive, Scoresby, Australia 3179 Ph: 1300 367 866 Fax: 1300 369 119 Website: davey.com.au Customer Service Centre 7 Rockridge Avenue, Penrose, Auckland 1061 Ph: 0800 654 333 Fax: 09 527 7654 Website: daveynz.co.nz Davey Water Products Pty Ltd Member of the GUD Group ABN 18 066 327 517 ® Davey is a registered trademark of Davey Water Products Pty Ltd.
PAGE 2
Congratulations! You are now the proud owner of one of the most advanced Electrolytic Spa Sanitising System in the world. Please read all information in this instruction book carefully before installing or operating your EcoSpa™ System. EcoSpa™ utilises low levels of pool salt at 2500ppm. This mild salt water in conjunction with a small amount of EcoSpa™ activator enables the water to be electrolysed using a safe and advanced electronic process to sanitise the water in your spa.
PAGE 3
NOTES IMPORTANT NOTICE FACTORS THAT WILL IMPROVE THE PERFORMANCE & LIFE OF YOUR SALT WATER BROMINATOR PLEASE READ THIS BEFORE OPERATING YOUR BROMINATOR There are THREE main factors that will damage your Brominator and reduce the life of the product. Please monitor the following factors in accordance with your installation & operating instructions. 1.
PAGE 4
ECO-SPATM INSTALLATION INSTRUCTIONS Davey® Repair or Replacement Guarantee (Refer to diagram next page) In the unlikely event in Australia or New Zealand that this Davey product develops any malfunction within warranty periods beginning from the date of original purchase due to faulty materials or manufacture, Davey will at our option repair or replace it for you free of charge, subject to the conditions below. 1.
PAGE 5
4. If you operate the EcoSpa in hard water (high calcium hardness) your cell may build up excessive calcium scale. This can be easily removed by cleaning it. To clean the cell, turn off the brominator, disconnect the cell leads from control box and unscrew the barrel unions from the plumbing. Add 1 part Hydrochloric Acid to 10 parts water in a suitable container and immerse the cell in this solution. It should not take more than a few minutes to clean.
PAGE 6
SETTING AND OPERATING THE ECO-SPA: 1. o set your EcoSpa™ first ensure the pH (7.2-7.4) and Total Alkalinity (80ppm) T are balanced then add bromine whilst the spa is running to reach a level of 4ppm Bromine. Verify this with a reliable test kit or seek the advice of your pool & spa professional. Please note the above bromine levels are recommended by Australian Standard AS 3633 for water above 26°C. 2.