User's Manual

Selecting Units of Measure

displayed in millibars, millimeters, inches, or hectoPascals. Note that you

can set each variable’s units independently, and at any time, as you like.

To change units:

1. Select the weather variable.

See “Selecting Weather Variables” on page 21.

2. Press and release 2ND then press UNITS.

The selected variable’s units will change. Repeat

steps 1 and 2 until the desired units appear.

For example, to change the Barometric pressure units, first select Baro-

metric pressure by pressing BAR. Next, press and release 2ND, then

press UNITS. Repeating these steps cycles through the units available

for Barometric pressure: millibars, millimeters, inches, and hectoPas-

cals.

Wind Speed and Direction

1. Press WIND to select wind speed.

2. Wind speed may be displayed in miles per hour (m.p.h.),

kilometers per hour (km/h), meters per second (m/s), and

knots (knots). The 10 minute average wind speed will be displayed in

the ticker.

A solid arrow within the compass rose indicates the cur-

rent wind direction. Arrow caps indicate up to six differ-

ent 10-minute dominant wind directions to provide a

history of the dominant wind directions for the past

hour.

3. Press WIND a second time to display the wind direction in degrees

instead of the wind speed.

Each additional WIND key press toggles the display between wind

speed and wind direction in degrees.

Outside and Inside Temperature

1. Press TEMP to select outside temperature.

Temperature may be displayed in degrees Fahrenheit (ºF)

or Centigrade (ºC).Temperatures can also be displayed in

degrees or in tenths of a degree.

2. Press TEMP again to select inside temperature.

GRAPH

UNITS

BAROMETER

Displaying Units:

Barometric Pressure Units: millibars (mb), millimeters (mm) and inches (in)

WIND

TEMP