User's Manual
Table Of Contents
- The steps for setting up your EnviroMonitor system:
- Planning Your System
- Set Up Nodes and Sensors
12
Set Up Nodes and Sensors
Contents of Node
Hardware Kit
D-Cell Battery
Compartment
(batteries not included)
Battery
Compartment
Door
Lithium Battery
Installed
Door Tabs
Remove Battery
Pull Tab
Solar Panel Cable
Mesh
status LED
Bluetooth
status LED
Solar Panel Jack
Sensor
Ports
Mesh
Antenna
Connector
for Internal or
External Antenna
1/4" Lock Washers
1/4" Hex Nuts
Backing Plates
Green 6-Wire
Sensor Connectors
Cable Ties
Adhesive
Mounts
Precision Screwdriver
1/4" x 1 1/4"
Lag Screws
#6 x 3/8 Screws
(disregard)
2 Large
&
2 Small
U-Bolts