Installation manual

The components unique to the Long Range Repeater board are:

• Transmitting Antenna Cable — Connects the repeater to the external transmitting

antenna.

• Receiving Antenna Cable — Connects the repeater to the external antenna receiving

a station or repeater signal.

Additional Tools for Setup

In addition to the tools required for standard wireless repeater installation, the following

additional tool is required to set up and install the long range repeater:

• 1/2'' socket

Long Range Repeater Hardware

Each long range repeater requires two antennas, one for receiving a station or wireless

repeater, and one for transmitting the data to another repeater or receiver.The two exter-

nal antenna choices are:

• Omni-direction

• Yagi (directional) antenna

You must purchase external antennas appropriate to your network architecture require-

ments

Note: Davis Instruments sells FCC Type approved antennas for the long range repeater. These antennas

are available for US customers only. US customer must use these antennas. Overseas customers

are responsible for procuring their own long range antennas for use with the long range wireless

repeater that comply with local regulations. See “Specifications” on page 13 for more information.

Omni-direction Antenna (#7655)

The omni-direction antenna includes the omni-directional antenna and mounting hard-

ware:

Omni Antenna

5/16"

U-Bolts

48"

Antenna

Cable

Flat Washer

Lock Washer

Nut