Installation - HD Addendum Owner manual

ManualsBrandsDAVIS ManualsFor the carDriveRight

DRIVERIGHT

STAINLESS STEEL STRAP MOUNTING INSTRUC-

TIONS

(For use with Heavy-Duty DriveRight

Installation Kits)

Assembly Parts:

• Stainless Steel Cable Tie

• Stainless Steel Magnet Mount

• Magnet

• Neoprene Rubber Strip

Tools Required: To assure that sufficient tension is applied to the stain-

less steel cable tie to prevent slipping of the Magnet Holder Assembly, a

tensioning tool must be used.

Two tensioning tools are available:

• The “Screwdriver” type

• The “Squeeze Handle” type

If the “screwdriver type is used, snips or cutters will be needed to trim the

stainless steel cable tie.

INSTALLATION INSTRUCTIONS

NOTE:Once the end of the cable tie is inserted into the clasp, it cannot be removed. Do

this only when you are ready.

1. Measure the neoprene rubber strip. Wrap it around the driveshaft at the loca-

tion where the magnet is to be placed. Cut the rubber strip squarely so that a

1.5” gap is left between the ends. This gap is where the magnet should be

placed.

Summary of content (4 pages)

PAGE 1
DRIVERIGHT® STAINLESS STEEL STRAP MOUNTING INSTRUCTIONS (For use with Heavy-Duty DriveRight® Installation Kits) Assembly Parts: • • • • Stainless Steel Cable Tie Stainless Steel Magnet Mount Magnet Neoprene Rubber Strip Tools Required: To assure that sufficient tension is applied to the stainless steel cable tie to prevent slipping of the Magnet Holder Assembly, a tensioning tool must be used.
PAGE 2
. Install the magnet into the holder and slide the stainless steel cable tie into the holder, securing the magnet inside. Note the orientation of the clasp to the holder. 3. Place the neoprene rubber strip around the driveshaft and loosely wrap the stainless steel cable tie over the rubber strip, positioning the magnet holder in the 1.5” gap (the magnet holder should rest directly on the shaft). Insert the end of the stainless steel cable tie into the clasp and slowly tighten.
PAGE 3
“SQUEEZE HANDLE” TYPE TIGHTENING TOOL Slide the installation tool over the stainless steel cable tie as shown and squeeze the handle to apply tension. If the handle is all the way closed and more tension is needed, release the handle and slide the tool towards the clasp. Again squeeze the handle until jthe desired tension has been reached. To cut off the end of the cable tie, hold tension and twist (either clockwise or counterclockwise).
PAGE 4
P/N 07395.058, Rev. C. 2/10/2003 Copyright Davis Instruments Corp. 2003 All Rights Reserved. DriveRight is a registered trademark of Davis Instruments Corp. 3465 Diablo Avenue, Hayward, CA 94545-2778 510-732-9229 • Fax: 510-732-9188 E-mail: info@davisnet.com • www.davisnet.