User manual

USB Hardware Installation

3. Review the license agreement, click I agree and click Next. The Choose

Destination Location dialog box displays.

4. Select the default location to install WeatherLink or find another location by

clicking Browse.

Note: If you are upgrading your software from a previous version, click Browse to search for

the directory or folder of the previous version of WeatherLink.

5. Click Next once you have selected a location. The Confirm Installation dia-

log box displays.

6. Click Next to start the installation. The Installing WeatherLink dialog box

displays the installation progress. The Installation Successful dialog box

displays once the software installation has been completed.

Note: During the installation process, the USBXPress Device Driver and the Bridge Driver, two

drivers required for USB connections are installed automatically.

7. Click OK. WeatherLink has been installed successfully.

USB Hardware Installation

Complete the local USB hardware installation by using the instructions below:

1. Locate the console or Weather Envoy that will receive the WeatherLink USB

connection.

2. For consoles only: Enter the console’s Setup Mode by pressing and holding

DONE, then pressing the down arrow (-). Entering Setup Mode ensures

that the station is not writing any data and saves the current daily weather

information to memory.

3. Remove the battery cover, the batteries, and AC-power adapter, if present.

Note: Failure to remove power to the console or Envoy before installing the data logger may

cause damage to the data logger or console. Plugging or unplugging the data logger

while power is applied can lock up or damage the data logger.

&?:HDWKHU/LQN?