Getting Started Guide Owner manual

Before You Install Envoy8X

Install the transmitting stations you will be using. Make sure that each

transmitter has a unique Transmitter ID (TX ID). (The factory default on

all transmitters is TX ID 1.) Refer to the transmitting station manual for

information on setting or changing the Transmitter ID.

You will need to know the Transmitter ID and transmitting station type

(such as Vantage Pro2 ISS or Leaf Wetness & Soil Moisture/

Temperature) when you configure the Envoy8X. If any transmitting

station is going through a repeater or repeaters, you will also need the

Repeater ID (A-H) of the last repeater before the Envoy8X. List your

transmitters and repeaters to refer to during setup of your Envoy8X.

Note: You can add transmitting stations in the future. Make sure that you assign

each an unused Transmitter ID.

Transmitting Station

Type

TX ID

(1-8)

Repeater

(A-H)

Transmitting Station

Location