Instruction Manual

Page 12 Wireless Leaf & Soil Moisture/ Temperature Sta-

Finishing the Sensor Connections to the Station

1. Secure sensor cables to the cable

tie mounts located next to the

grommets.

2. To prevent fraying or cutting of

cables, secure them so they will not whip

about in the wind. Secure a cable to a metal

pole by wrapping electrical tape around

them both. Make sure cables are secure by

placing clips or ties approximately every 3 –

5' (1 – 1.6 m).

Note: Do not use metal staples or a staple gun to secure cables. Metal staples —

especially when installed with a staple gun — have a tendency to cut the cables.

Mounting the Sensor Against a Wooden Surface

To mount the sensor against a

wooden surface, secure the

sensor to the surface using the

#8 wood screws as shown

below.

Cable Tie

When tightening

cable tie, make sure

cables are on top of

cable tie mount.

Cable Tie

Mount

Securing Sensor Cables

Cable Clip

Cable Tie

Securing Cables with Clips and Tie

Mounting on a Wooden Surface