User Manual

10
Assemble the Radiation Shield
To assemble the radiation shield plates you will need the plates and studs
assembly, as well as the rest of the plates, three #8 flat washers, three #8 split lock
washers, and three plastic wing nuts.
1. Slide the three open plates and the two remaining closed plates over the
threaded stud ends protruding from the top of the plate and studs assembly.
2. Place flat washers, lock washers, and plastic wing nuts over the protruding
stud ends. Proceed to mount the shield. See “Mounting on Top of a Post:” on
page 13.
Plates and Studs
Assembly
#8 Lock Washer
#8 Flat Washer
#8 Wing Nut
Complete Plate
Assembly
Open Plate
Open Plate
Open Plate
Closed Plate
Closed Plate
with Bracket
attached