User Manual

4
5. Once secured, adjust the position of the sensor so the probe and
approximately 1/4” (6 mm) of cable protrude from the clip mounts.
6. Place the cable clamp around the sensor cable approximately 8” (20 cm) from
the probe.
7. Secure the cable clamp to one of the remaining mounting posts (using a #4 x
1/2” pan head self-threading screw and a #4 flat washer) so that a loop of
cable is formed.
Make sure to tighten the clamp with the flat side up and the bulge side down.
Tighten the screw completely so that the cable cannot move within the cable
clamp. If using a stainless steel temperature probe, wrap a cable tie around the
sensor and cable as shown below to hold the probe in place.
Cable Clamp
Temperature Probe
Cable Clamp
Stainless Steel Temperature Probe
Cable Tie