User Manual

7
If you are attaching the radiation shield to the side of a post or to a
wall or a pipe:
1. Slide the three open plates and the two remaining closed plates over the
threaded stud ends protruding from the top of the plate and studs assembly.
2. Place the flat washers, lock washers and plastic wing nuts over the protruding
stud ends.
3. Rest the partially assembled radiation shield on a flat surface and proceed to
mount the shield. See “Mount the Radiation Shield” on page 11.
Complete Plate
Assembly
Plates and Studs
Assembly
Open Plate
Open Plate
Open Plate
Closed Plate
Closed Plate
#8 Wing Nut
#8 Lock Washer
#8 Flat Washer