User`s guide

USING THE SOFTWARE

Setup Menu

Set Archive Interval

You may choose to store data to the WeatherLink’s archive memory at an interval

of 1, 5, 10, 15, 30, 60, or 120 minutes. This interval is known as the archive interval.

For information on archive memory and the effect that the archive interval has on

the amount of data which may be stored in the WeatherLink’s archive memory,

see “Archive Memory” on page 91.

Note:

Be aware that setting the archive interval clears your archive memory. You should download

data before changing archive interval (see “Download” on page 16).

1. Choose Set Archive Interval from the Setup menu.

The Set Archive Interval dialog box appears.

RCHIVE

NTERVAL

2. Select the desired archive interval and choose OK.

The software warns you that it is about to clear the archive memory.

3. To continue, choose OK.

The software sets the archive interval and clears the archive memory.

Set Barometer

You must set the barometer on your station console using the software (provided

your station has a barometer). For performance reasons, the software reads the

necessary calibration number for the barometer from the station’s conﬁguration

ﬁle, rather than reading it from the console itself (see “Calibration Numbers” on

page 93). Therefore, in order for the software to display the correct barometric

pressure, you must set the barometer from the software.

1. Choose Set Barometer from the Setup menu.

The software opens the Set Barometer dialog box.

AROMETER