Instruction manual

Page 12 Spread-Spectrum Radio Modem Installation Kit

Run The Modem Conﬁguration Program

Use the supplied modem conﬁguration program to conﬁgure the RM.

1. Place the Modem Conﬁguration Disk in your disk drive.

2. Choose Run from the File Menu (Windows 3.1) or the Start Menu (Windows 95).

3. Type A:\CONFIG and press Enter (or choose Ok).

The Wireless Modem Conﬁguration Program dialog box appears.

4. Select YDI Model 910 Radio from the Model Type drop-down list.

5. Select the COM port to which the RM is connected from the COM Port drop-down list.

If you don‘t know the serial port number, start by choosing COM 1. If you

get a program error when you attempt to conﬁgure the RM, try with COM 2,

and so on until you ﬁnd the correct serial port setting.

6. Select a “name” for this RM from the Radio Name drop-down list.

You may choose between “Base” and a series of numbered “Remote” sta-

tions.

7. Select the channel on which you want the RM communicating from the Channel drop-

down list (all radios in the network must use the same channel).

Consult the manual supplied by the radio modem manufacturer for infor-

mation on choosing a channel.