Instruction manual

Page 20 Spread-Spectrum Radio Modem Installation Kit
Installing Solar Power Kit & Battery
Consult the manuals supplied with the Solar Power Kit for instructions. Note
the following, however, as you proceed with the installation.
✦ Use the tab adapter to attach the black battery wires to the battery.
Before installing the battery, slide the tab adapter onto the black
(ground) terminal. Attach the black battery wire (supplied with the
Spread-Spectrum Radio Modem Installation Kit) and the black wire on
the battery cable (supplied with the Solar Power Kit) to the tab adapter;
see the wiring diagram in “Connecting Timer Wires” on page 25 or
“Connecting Alarm Output Module Wires” on page 27. Make sure you
have access to the free end of the wires after the battery is installed.
✦ Do not connect the solar panel or the battery to the regulator circuit.
Make sure you have made no connections at B1 and B2 on the regulator
circuit before proceeding.
Installing Radio Modem
Follow the instructions below to install the RM. Install the station console/
WeatherLink prior to installing the RM.
1. Thread the Velcro strap through the slots of the mounting plate.
Velcro
Strap
Mounting
Plate