Instruction Manual

Page 6 Addendum, Rev B
2. Lift the rain collector base off of the mounting bracket.
Tip: For easier re-assembly, mark the holes in the mounting bracket used by the
rain collector base, the holes used by the radiation shield, and the orientation of
the bracket relative to the radiation shield.
3. Remove the cardboard packing insert and discard.
4. Remove the three (3) screws connecting the mounting bracket to the radia-
tion shield.
5. Lift the mounting bracket off of the radiation shield.
6. Remove the top two (2) radiation shield plates to expose the fan plate and
junction board.
2" Screws (3)
Lock Washers
Flat Washers
Closed Plate
(no hole in center)
Open Plate
(hole in center)
Solar Power
Cable
SOLAR MODELS
Power Cable
AC MODELS
Sensor
Cable
Fan Plate
Battery Compartment
Mounting Bracket
SOLAR MODELS
Mounting
Bracket
AC MODELS
Junction Board
Direction
of air flow
Removing the Mounting Bracket
ISS Fan Rev B.fm Page 6 Thursday, November 14, 2002 4:29 PM