Owner manual

Setting up the Weather Echo/Weather Echo Plus Page 13
To add past rainfall totals:
1. Press the MODE key to change from ID Code to Total Rain.
2. Input the first digit value using the + or - key.
ADDING PAST RAINFALL TOTALS
3. Press the SET key to accept the value and move on to the next digit.
4. Repeat steps 2 and 3 to input the remaining digits.
Next, you need to input barometric data, select the correct hemisphere for
forecasting, and calibrate the rain gauge.
To enter barometric readings from the host station or other station:
1. Press and hold down the MODE button to return to the home screen.
2. W
ait for approximately 1 minute until the unit receives barometric data from the host
station.
3. Press and hold down the MODE key to return to the set up screen. Change to the new
screen after you input the rainfall totals.
A new screen appears as shown below with an empty barometer field.
Note:After 1 minute, you can view data in the barometer field only if your host station has a barome-
ter installed.
ENTERING BAROMETRIC DATA
4. Input the first digit value using the + or - key.
5. Press the SET key to accept the value and move on to the next digit.
6. Repeat steps 2 and 3 to input the remaining barometric digits.
RAIN
in
.
.
.
TOTAL
TIME
ID CODE
DAY
YEAR
MONTH
Flashing digit
BAROMETER
N=0 S=1
Hemisphere
RAIN
Enter barometric data here
in
.
.