Installation & Assembly

4
EK7861183
INSTALLATION INSTRUCTIONS
LEGAL DISCLAIMER:
● This instrucon guide is done as a public service to customers of Dawn Kitchen & Bath Products, Inc. (“Dawn®”). Please consult professionals for special situaons or further assistance.
● All products should be inspected by customers upon receipt and before any installaon. Any defecve product should be reported immediately and should NOT be installed.
● Requirements may vary for installaon in a granite, marble, stone, or butcher block countertop.
● Installaon by professional installers is highly recommended. Dawn assumes no liability for any damages incurred through the use of informaon provided in this guide.
A: Hot Water
B: Cold Water
Thread
Seal Tape
Connect to the water
supply and ush to
check for leaks.
Assemble the supply hoses to
the faucet. Be careful not
to twist the supply hoses.
On the handspray side of the
hose, measure 15” down from
the body of the faucet and make
a mark. Install the hose weight at
the mark. Reposion the hose
weight as necessary to insure the
handspray pulls out and retracts
smoothly.
Make sure that the supply hoses
do not interfere with the pullout
hose. If necessary, reposion the
hoses.
Remove the rubber washer
(24), metal washer (25), and
mounng nut (26) from the
faucet. Insert the faucet
through the faucet hole. From
below the deck, assemble the
mounng hardware back to
the mounng shank. Tighten
the mounng screws (27).
Make a faucet hole. Make sure the
mounng surface is clean and dry.