Owner's Manual

16
THE PUCK VOICE ACTIVATED SYSTEM INSTALLATION
Remove the Puck from the box.
Please take a minute to familiarize yourself with the voice commands
listed on the page 17.
Locate the Puck connector and connect it with the plug as shown in
the picture.
The Puck Voice Control will arrive in the
Off position and you will need to activate
the Puck by selecting an invocation
command of your preference.
Use the slider switch on the back side of
the Puck to select the invocation phrase
you wish to use, either “HELLO DAWN”
or “HELLO BED”.
Note: If you have a split base, each side
must have a different invocation phrase
in order to work independently.
STEP 2
STEP 1
STEP 3
STEP 4
FOLLOW THE INSTALLATION STEPS BELOW TO SET UP THE PUCK VOICE ACTIVATED SYSTEM.
WAKE UP DEVICE
To use the Puck Voice Activated System, simply say the invocation
command you chose during setup, either “HELLO DAWN” or “HELLO
BED”, and wait 1-2 seconds for the microphone to activate. Once the
microphone is activated, indicated by the blue light, it will be active
for 8 seconds. While the microphone is active you can now use any
of the voice commands listed below to control your adjustable base.
If no command is heard within 8 seconds, the Puck will enter “sleep
mode” and the microphone will be deactivated.
Proceed to the next page for list of voice commands.